Orion System HB Mini - Manual (Page 11)

HB Mini Controller
Technical Guide
11
Entering Passcodes
The HB Service Tool is used to program setpoints and view the status
of the HB Mini Controller. It is connected to the HB Mini Controller by
means of a modular cable. The cable is connected between the HB
Service Tool and the HB Mini Controller board. The HB Service Tool
doesn’t require batteries or a separate power source as all power to
operate the HB Service Tool is provided through this cable. The HB
Mini Controller must be powered in order for the HB Service Tool to
function.
Device Address
064
When the HB Service Tool is initially powered up, the program version
and the current time and date will be displayed. After the initial power
up, this screen only appears when the HB power is removed and then
reapplied. Press ENTER and the HB Service Tool will check all current
parameters. When it has finished this checking procedure, press EN-
TER and the main HB programming screen will be displayed. If you
want to change setpoints you will need to enter a passcode at this time.
If you only want to view status, a passcode is not required and you can
proceed to view status directly by pressing the ENTER key.
If you want to change the Passcode, hold down on the UP and DOWN
SELECT ARROWS simultaneously and the following screen will be
displayed.
Enter Code
AAA A
The passcode entry screen uses a four digit alpha passcode. Position the
cursor under the first letter field. To select the desired letter, use the
ADJUST ARROWS. The UP arrow increases through the alphabet and
the DOWN arrow decreases. When the desired letter appears, press the
RIGHT ARROW key to advance to the next letter field. Once all four
letter fields spell the desired passcode, press the ENTER key.
Available passcodes are:
„
“OPER” = The Operator is at level 1 for Status and
Setpoints
„
“CONT” = The Contractor is at level 2 for Status, Setpoints
and Force Modes
Again, if no passcode is entered, the default level is 0 and only allows
viewing of the status screens.
General Procedures
When the HB Service Tool is initially powered up, this screen will be
displayed. Press ENTER to proceed to the next screen.
Version: X.XX
Date: XX/XX/XX
Enter your passcode as described in the previous section and proceed
by pressing the MENU key. The following screen will be displayed.
Device Address:
064
Line #2 displays the default address for the HB Mini Controller. Press
the ENTER key. The following screen will be displayed.
Device Name
HBMini
Line #2 displays the controller name or program name. Press the EN-
TER key to advance.
Module Selection Screens
After pressing ENTER in the previous step, the first available program-
ming module screen appears. All of the HB Mini Controller Status and
Setpoint Screens are grouped in specific modules designated by a spe-
cific function name.
Main Status
Fan Status
Using the select arrows, scroll to select the desired module on line #1
and press the ENTER key. The other available module screens are listed
below in order that they would appear as you scroll down.
Programming With The HB Service Tool