OWON ODP Series - Manual (Page 16)

4.Quick Start
11
Current working mode is Series
Current working mode is Plus-minus
The buzzer is on
The buzzer is off
The system is in Timer Status
4.2 General Inspection
After you get a new ODP Series power supply, it is recommended that you should make a
check on the instrument according to the following steps:
1. Check whether there is any damage caused by transportation.
If it is found that the packaging carton or the foamed plastic protection cushion has
suffered serious damage, do not throw it away first till the complete device and its
accessories succeed in the electrical and mechanical property tests.
2. Check the Accessories
The supplied accessories have been already described in the "Appendix A: Enclosure"
of this Manual. You can check whether there is any loss of accessories with reference
to this description. If it is found that there is any accessory lost or damaged, please get
in touch with the distributor of Lilliput responsible for this service or the Lilliput's
local offices.
3. Check the Complete Instrument
If it is found that there is damage to the appearance of the instrument, or the
instrument can not work normally, or fails in the performance test, please get in touch
with the Lilliput's distributor responsible for this business or the Lilliput's local offices.
If there is damage to the instrument caused by the transportation, please keep the
package. With the transportation department or the Lilliput's distributor responsible
for this business informed about it, a repairing or replacement of the instrument will
be arranged by the Lilliput.
4.3 Power-On Check
4.3.1 AC Power Input Setting
ODP Series adopt 110V/220V AC power source. Users should regulate the voltage scale
of the Power Switch according to the standards in their own country (see Figure 4-2) at
the rear panel and use an appropriate fuse.