Posiflex JIVA HS-2310 - Manual (Page 12)

Part 12
paper roll compartment at both sides as arrowed. With point A going in first
then B secondly, then the 58mm paper roll sub compartment is formed
accordingly.
Printer Interface
Although the printer is USB interface, it is converted to virtual COM port by
software at delivery.
Advanced Analysis Tool
This printer supports Hexadecimal Dump for experienced user to view
exactly what data the printer receives. This can be useful in finding software
problems.
To start the dump mode: One way is to turn off printer; Open print hood; Hold
down FEED button while turning printer on; Close the hood.
The other way is to open cover, press down FEED button until the error LED
flashes; Close cover.
To stop the dump mode: Open cover; Press the FEED button to print out the
last line; open cover then close.
During dump mode: All commands except DLE EOT and DLE ENQ are
disabled.
FINGER PRINT SENSOR RECOGNITION
The finger print sensor is intended to help recognize encrypted data by way of
accurate fingerprint representation and image. User is required to perform a
fingerprint sensor recognition job by actually operating on externally
supported finger print recognition software (not provided by Posiflex) to get a
confidential fingerprint image which is highly compressed and digitally
encoded accurate representation of fingerprint features. The template is created
when a user registers a finger and is stored in an encrypted file.
Behind the touch terminal, the finger
print sensor is located at the upper
right corner side as illustrated. After
the sensor is enabled, the sensor
blinks in red to detect with finger
presence, blue for standby mode. If
you enable your terminal’s power-
saving function but your third party
application does not support this, then your fingerprint sensor will enter “sleep