Posiflex JIVA HS-2310 - Manual (Page 18)

Part 18
CUSTOMER DISPLAY
Please follow the instructions on the manual that comes along with the
customer display when it is installed.
DISPLAY ISSUES
Main LCD Display
For best viewing result please set your display resolution at 1024 x 768 with
high color for “10” & “12” type; 800 x 600 for 8”.
VGA Port
The VGA port in this terminal supports top mount 2
nd
display. To support the
+12V DC power to the 2
nd
display monitor, have a qualified technician to set
a software setting to supply the required power through the internal BIOS
setting according to Posiflex technical information. Do not connect other
monitor to this port before the power in this port is disabled.
and / or +12
V DC through pin 1 LM-3112
SERIAL PORTS – COM1/2/3
This terminal features 3 COM ports. All can be configured to supply +5 V DC
output through BIOS setup or jumper settings. COM1/2 ports are standard
DB9 connector as status at delivery. COM3 is RJ45 serial port as status at
delivery, it can convert to DB-9 connector of DB25 connector if the option
conversion cable is applied.
PARALLEL PORT
For this terminal, the parallel port with DB25 female connector is mandatory.
It should be connected to the LPT port on the top I/O plate.
TOUCH PANEL
All paragraphs below are applicable for models with touch panel only. The
user of those models without touch panel can ignore them and consider this
user’s manual ends here.
Mouse Emulation
When the touch driver is properly installed, this touch panel works exactly like
a standard mouse for each interface. However, if the system is running under
safe mode, the touch panel calibration may become unsatisfactory due to
disabled drivers. It is recommended to use a standard USB mouse or keyboard
in this mode.