Posiflex JIVA HS-2310 - Manual (Page 14)

Part 14
With power saving mode, the smart card can be waged between suspending
and wake-up modes via host.
CUSTOMER DISPLAY UPGRADE KIT (OPTIONAL)
Rear Top Mount Customer Display
To mount the rear top mount upgrade kit like PD/LM6507, PD-340UE, PD-
2607UE or LM-2008 on the back of the terminal,
A) Release the top cover on the I/O plate.
B) Adjust the rear bracket of 2
nd
display to its adequate angle,
release the rear bracket cable cover and connect one USB
cable end at the 2
nd
display USB port, the other at the USB
port on the top I/O plate by routing thru the cable exit hole.
Apply carefully the 4 small fixation shoulder screws that come
along with the above 2
nd
display series to the back of this
terminal at the screw hole circled in the below picture.
Please do not screw them to the bottom. Hook the rear bracket
of the upgrade kit onto the shoulder screws. Slide down the
upgrade kit and gently tighten the shoulder screws.
C) Close the rear bracket cable cover as illustrated.
A) B)
C)
Do not overdo the tightening or unrecoverable thread damage will occur.