Q-See QC40198 - Manual (Page 111)

WEB OPERATION
QC40198 User Manual
102 | P a g e
Figure 7-47
Please refer to the following chart for detailed information:
Parameter Function
Event
Type There are three types: Motion detection/video loss/Camera Masking.
Channel Select channel name from the dropdown list.
Enable You need to put a checkmark to enable motion detection function.
Sensitivity There are six levels. The sixth level has the highest sensitivity.
Region  Region: If you select motion detection type, you can click this button
to set motion detection zone. The interface is shown in Figure 7-41.
There are PAL 22X18/NTSC 22X15 zones. Right click mouse you can
go to full-screen display mode. Click OK button to save your motion
detection zone setup.
Period  Motion detection function becomes activated in the specified periods.
 There are six periods in one day. Put a checkmark to enable
corresponding period.
 Select date. If you do not select, current setup applies to today only.
You can select all week column to apply to the whole week.
 Click OK button, system goes back to motion detection interface;
please click save button to exit.
Anti-dither System only memorizes one event during the anti-dither period. The
value ranges from 0s to 15s.