Q-See QC40198 - Manual (Page 68)

MAIN MENU
QC40198 User Manual
59 | P a g e
5.3.8 Pan/Tilt/Zoom
The pan/tilt/zoom setup includes the following items. Please select channel first. See Figure 5-22.
 Protocol: Select corresponding PTZ protocol such as PELCOD.
 Address: input corresponding PTZ address.
 Baud rate: Select baud rate.
 Data bit: Select data bit.
 Stop bit: Select stop bit.
 Parity: There are three choices: none/odd/even.
After completing the setup click save button, system goes back to the previous menu.
For detailed setup, please refer to Chapter 4.9 preset/patrol/pattern/scan.
Figure 5-22
5.3.9 Display
Display setup interface is shown below. See Figure 5-23.
 Transparency: Here you can adjust transparency. The value ranges from 128 to 255.
 Channel name: Here you can modify channel name. System supports up to 25-digits. Please note all your
modifications here only apply to combo DVR local end. You need to open web or client end to refresh channel
name.
 Time display: You can select to display time or not when system is playing back.
 Channel display: You can select to display channel name or not when system is playing back.
 Overlay information: System displays some information on the screen for your reference.
 Resolution: There are five options: 1400×900(default), 1280Ч1024, 1280Ч720, 1024Ч768, 800Ч600. Please
note the device needs to reboot to activate setup changes.
 Display mode: You can select from the dropdown list.
 Enable tour: Activate tour function.
 Interval: Input proper interval value here. The value ranges from 5-120 seconds. In tour process, you can use
mouse or click Shift to turn on window switch function. Stands for opening switch function, stands for
closing switch function.
 Motion tour type: System supports 1/8 window tour.
 Alarm tour type: System supports 1/4/9/16 window tour.
Please highlight icon to select the corresponding function.