Quantum Composers 9730 Series - Manual (Page 18)

8-18
Channel Test Menu (FUNC + A, B, C, or D)

Page0
o Line0 – empty
o Line1 – PreTest: Disabled
o Line2 – empty
o Line3 – empty

Page0
– Alt
o Line0 – empty
o Line1 – PreTest: Enabled
o Line2 – PreMeas: “measured resistance”
o Line3 – empty

Page1 – (Only available when PreTest is Enabled)
o Line0 – empty
o Line1 – PreMax: <pretest maximum resistance>
o Line2 – PreMin: <pretest minimum resistance>
o Line3 – IPreMax: <pretest measurement current>
Setting Channel Pre-Test Parameters
PreTest: Enables or disables pre resistance test and requirements for
the channel.
PreMeas: Displays the measured resistance from the last run pre-test.
PreMax: Sets the maximum resistance allowable for pulse generation.
PreMin: Sets the minimum resistance allowable for pulse generation.
IPreMax: Sets the test current for measuring the resistance.

Page2
o Line0 – empty
o Line1 – PostTest: Disabled
o Line2 – empty
o Line3 – empty

Page2 - Alt
o Line0 – empty
o Line1 – PostTest: Enabled
o Line2 – PstMeas: “measured resistance”
o Line3 – TstType: Standard, Outside, Outside Pre

Page3 – (Only available when PostTest is Enabled)
o Line0 – empty
o Line1 – PstMax: <post-test maximum resistance>
o Line2 – PstMin: <post-test minimum resistance>
o Line3 – IPstMax: <maximum test current>
Setting Channel Post-Test Parameters