Quantum Composers 9730 Series - Manual (Page 35)

10-35
Example 2:
20 ms pulsewidth, 100ms rate, 4 burst, internal trigger, burst mode operation.
:PULSE0:MODE BURST<cr><lf> sets system mode to burst
:PULSE0:RATE 0.1<cr><lf> sets the system rate to 100 ms
:PULSE0:TRIG:MODE DIS<cr><lf> disables the external trigger
:PULSE1:WIDT 0.020<cr><lf> sets pulsewidth to 20 ms
:PULSE1:STATE ON<cr><lf> enables channel A
To start the pulses use either of the following commands:
:PULSE0:STATE ON<cr><lf> starts the pulses
:INST:STATE ON<cr><lf> alternate form to start pulses.
9730 SCPI Command Summary
Instrument Commands
Keyword Command Sub-
Command
Parameter
Range Notes
:INSTrument Subsystem
:CATalog ? Query only. Returns a comma-separated list of the
identifier strings for all channels. A two channel
instrument would return: T
0
, CHA, CHB.
:FULL ? Query only. Returns a comma-separated list of the
identifier strings of all channels and their associated
number. A two channel instrument would return: T
0
, 0,
CHA, 1, CHB, 2.
:COMMands ? Query only. Returns an indented list of all SCPI
commands.
:NSELect 1-4 Selects a channel using the channel's numeric value.
All channel specific commands will refer to the selected
channel.
:SELect T
0
/ CH[A-D] Selects a channel using the channel's identifier string.
All subsequent channel specific commands will refer to
the selected channel.
:STATe 0/1 or
OFF/ON
Enables / Disables the output for all channels.
Command is the same as pressing the RUN/STOP
button.
:PRETest 0/1 or
OFF/ON
Runs the resistance pre-test for all pre-test enabled
channels.
:POSTtest 0/1 or
OFF/ON
Runs the resistance post-test for all pre-test enabled
channels.