Quantum Composers 9730 Series - Manual (Page 21)

8-21
SYSTEM Menu (FUNC + 3)

Page0
o Line0 – empty
o Line1 – Front Sync: Disabled, T0, ChA, ChB, (ChC, ChD)
o Line2 – Rear Sync: Disabled, T0, ChA, ChB, (ChC, ChD)
o Line3 – empty

Page1
o Line0 – empty
o Line1 – Interface: RS232
o Line2 – Baud Rate: <RS232 baud rate>
o Line3 – Echo: <RS232 echo>

Page1 - Alt
o Line0 – empty
o Line1 – Interface: USB
o Line2 – empty
o Line3 – empty

Page1 - Alt
o Line0 – empty
o Line1 – Interface: Ethernet
o Line2 – empty
o Line3 – empty
Note: Ethernet Interface will only display if unit was ordered with the
Ethernet Option.

Page2
o Line0 – empty
o Line1 – Key Rate: <key rate>
o Line2 – Key Vol: <key volume>
o Line3 – empty

Page3
o Line0 – empty
o Line1 – Mark: <decimal point indicator>
o Line2 – LCD: <LCD brightness>
o Line3 – empty
Setting System Parameters
Front Sync: Sets the source of the front panel sync output signal set to
the front panel. Choices are Disabled, T
0
, ChA, and ChB for
two channel instruments, with ChC and ChD added for four
channel instruments.