REMKO ETF 400 - Manual (Page 11)

6. Switch the unit back on using
the operating switch [2].
Unit operation with hose
connection
The condensate container has
been provided with a connection
port (11mm ø) .
After removing the condensate
container, a water hose (not
provided) may be connected
to this connection port.
The following procedure must
be followed when connecting
a water hose:
1. Open the front sealing flap
and remove the sealing plug.
2. Insert the customer-
provided drainage hose
into the connection port
(secure and seal with a clamp
if necessary).
Condensate
Depending on the air temperature
and the relative humidity,
condensed water will drip into
the condensate trap and into
the condensate container below
either continuously or only during
the defrosting phases.
A float is located inside
the condensate container.
In the event that the container
is full, the float will activate
amicroswitch which will switch off
dehumidification mode.
The unit will switch off
and the yellow control lamp will
illuminate.
To empty the condensate
container, the following procedure
must be followed:
1. Move the operating switch [2]
to the "0" (off) position.
2. Open the front sealing flap [K].
3. Remove the condensate
container [B] by carefully pulling
the container forwards out
of the guide rails.
NOTE
The units are only functional
when operated with a correctly
inserted condensate container.
NOTE
After being emptied,
the condensate container incl.
float must be checked for
damage, contamination etc.
NOTE
Beware of dripping
condensate.
After switching off the units,
the evaporator may continue
to defrost under the influence
of the ambient temperature.
4. Open the valve on the pouring
opening sidewards.
4. Pour the condensate into a drain
or similar receptacle.
5. Close the pouring opening
and carefully insert
the condensate container back
into the unit.
NOTE
Ensure that the small black
sealing plug is always inserted
into a fixed connection port.
Missing plugs will give rise to
uncontrolled water discharge.
Valve
B
K
11