REMKO ETF 400 - Manual (Page 12)

3. Insert the condensate
container back and route
the drainage hose through
the slot on the right next
to the condensate container
through the base of the unit.
4. Lock the front sealing flap
in place.
Move the operating switch
to the "0" (off) position.
If the units
are to be left unused
for extended periods,
disconnect from
the mains.
Empty the condensate container
and dry with a clean cloth.
When storing the unit, cover with
a plastic sheet/foil if necessary
and store in an upright position
in a sheltered and dry location.
For easy transportation, the units
are equipped with 2 large
wheels and an easy-to-dismantle
transportation handle.
When transporting the units,
observe the following:
1. Before each change of location,
switch off the unit and remove
the mains plug from the mains
socket.
2. Empty the condensate container.
3. If moisture remains
on the evaporator or water
remains in the condensate
container, the units must only
be transported in an upright
position.
5. Drain the condensate into
a lower-lying drain.
To operate the units,
the condensate container must
always be inserted correctly
and the sealing flap must always
be locked.
Transportation Decommissioning
NOTE
Beware of dripping
condensate.
After switching off the units,
the evaporator may continue
to defrost under the influence
of the ambient temperature.
NOTE
Ensure that the drainage
hose is placed at an angle
to the drain to allow
the condensate to drain from
the condensate container
without hindrance.
NOTE
Beware of dripping
condensate.
After switching off the units,
the evaporator may continue
to defrost under the influence
of the ambient temperature.
ATTENTION
The mains cable must never
be used as a pull cord or fixing
device.
!
ATTENTION
In order to prevent damage
to the compressor, wait for
approx. 2 to 3 minutes before
switching the unit back
on again.
!
12
REMKO ETF 400