REMKO Multi-talent Plus - Manual (Page 13)

Hot water
Designation Description
T-WW
Current hot water temperature and hot water target temperature (see user hot water
T-WW target). [sensor 06]
T-WW U Current temperature of the buffer tank bottom [sensor 12] (e.g. systems with a solid fuel boiler)
WW demand Status of heat demand hot water (on/off).
WW pump Status of the hot water charge pump (on/off / 3-way switch valve.
WW enable Enable water heating (on/off).
Circulation pump Circulation pump status (on/off).
Heating circuit 1/2
Designation Description
T-supply
Current supply temperature [sensors 05/08] and supply target temperature following pressing of the
respective function key.
Heating circuit enable Heating circuit in heating mode (on/off).
Heating circuit pump Heating circuit pump status (on/off).
B-warm up-time Last required warm up-time with active warm up optimisation.
Solar / MF
Designation Description
MF 1 Status of the relay MF 1 (on/off) outlet A8 - 2nd heating appliance.
MF 2 Status of the relay MF 2 (on/off) outlet A9 - charge pump indoor unit.
T-MF 3 Current temperature of the MF 3 sensor [sensor 13] - solid fuel boiler.
MF 3 Status of the relay MF 3 (on/off) outlet A10 - 3-way switch valve cooling / MP cooling
MF 4 Status of the relay MF 4 (on/off) outlet A12 - solar.
T-solar 1 Current collector temperature 1 [sensor 14].
T-WW Current hot water temperature and hot water target temperature [sensor 6].
T-WW U Current temperature of the buffer tank bottom [sensor 12] (e.g. systems with a solid fuel boiler).
Solar pump 1 Status of the collector pump 1 (on/off).
Load Sp WW Status of the tank charge pump 1 (on/off) not used by REMKO.
Level 4 - DISPLAY - Description of parameters and settings - continued
13