Soundtube FP6020-II - Manual (Page 2)

1. Unpack FP speaker pod
and FP Dome. 2. Thread signal wire through
hole in dome and dome clamp. 3. Hand tighten dome clamp.
6. Connect signal wire
to audio source.
Note - For Mono operation see
diagram on reverse side.
4. To use junction-box w/
face plate (not supplied):
Attach mounting bushing to
J-box. Thread signal wire thru
mounting bushing, adjust height
of dome and tighten bushing.
5. To use hanging cable:
Attach mounting bushing
to cable hanging bracket.
Thread signal wire thru
mounting bushing, adjust
height of dome and tighten
bushing.
Install Instructions For:
FP6030 and FP6020 speakers
1.435.647.9555 | 800.647.TUBE | www.soundtube.com
FP Series
FP Series FP Series
8. Turn high pass filter on or
off. When switch is in “up”
position, signal is full-range.
Note - In full-range, bass frequencies
will bleed outside the dome due
to their longer wavelengths.
7. Adjust audio level
for ambient sound levels.
See chart below for
recommended levels.
Hang dome 1.5 to 2.0 feet above listener.
Hanging height Guidelines
Guidelines for setting the SPL
1. Measure ambient noise level of the venue at the busiest time.
2. Stand under the dome and set volume level to +6 dB above the
ambient noise level measurement.
3. Step outside the dome and check to see that the SPL of the
Dome is not too loud as compared to the ambient noise level.
4. Adjust Equalization to match the program music being played.
*Note - Bass frequencies will bleed outside the dome due to
their longer wavelengths.
5. Adjust SPL as necessary. This level will vary based upon the
height of the dome.
1.5 ft to 2.0 ft 45.72 cm to 60.96 cm