Sundance SMT1026 - Manual (Page 43)

4.1.4 SMT384
This section explains how to use the "Configure FPGA-only module" user interface.
For more information on how to set the parameters please look at the SMT384 user
manual .
1 - FPGA Configuration:
Bitstream: Select the FPGA bitstream. (This field is not used when the "Quick
Configuration" box is checked.)
Quick Configuration: Check this check box if the FPGA has already been configured with
the right bitstream. When this check box is checked, only a start key is sent to the FPGA
to reconfigure it.
Configure FPGA: Press this button to configure the FPGA of the SMT384.
2 - ADC Configuration:
Channel selection: Select the output channel(s) .