Sundance SMT1026 - Manual (Page 48)

Source code
The source code is similar for all the supported FPGA-only modules:
1- Open the FPGA library.
2- Reset the board and TIM.
3- Configure the FPGA.
4- Configure the ADCs/DACs.
5- Start the acquisition on the ADCs or trigger the DACs.
6- Save data to file (ADCs).
Tip: Change the value of the #define directives at the beginning of the program to
change the parameters. Don't forget to recompile!
5.3 Output
This folder contains the executable application.
It's installed in the following directory: " C:/Program
Files/Sundance/SMT6026/Examples/SMT391/Output ".
Remark: SMT391 can be replaced by the number of the board you are interested in.