Super Systems 9120 RPSC - Manual (Page 11)

Model 9120 Redundant Probe System - Color
4580 – Redundant Probe System – Color Page 11 of 23
2400 19200 76800
4800 28800 115200
9600 38400
RS232A Mode
This will allow the user to set the RS232A mode.
Note – This must be set to Modbus for the
Touchscreen .
If the Mode is switched, the screen will no longer communicate with the instrument, and the
RPS unit will need to be returned to Super Systems, Inc for repair. The Mode should be fixed
at Modbus
.
The options are: Modbus, H2 cell.
Host 485 Baud
This will allow the user to set the Host 485 baud rate.
Note – This must be set to 19200 for the
Touchscreen .
If the Baud rate is switched, the screen will no longer communicate with the instrument, and
the RPS unit will need to be returned to Super Systems, Inc for repair. The Baud rate should
be fixed at 19200
.
The options are:
1200
14400 57600
2400 19200 76800
4800 28800 115200
9600 38400
Host 485 Mode
This will allow the user to set the Host 485 mode.
Note – This must be set to Modbus for the
Touchscreen .
If the Mode is switched, the screen will no longer communicate with the instrument, and the
RPS unit will need to be returned to Super Systems, Inc for repair. The Mode should be fixed
at Modbus
.
The options are: MMI, or Modbus selectable.
Host 485 Address
This will allow the user to set the Host 485 address. The range is 0 to 249.
Slave 1 Baud
This will allow the user to set the Slave 1 baud rate.
Note – This is configurable, but currently, it is
not used with the RPS .
The options are:
1200
14400 57600
2400 19200 76800
4800 28800 115200
9600 38400
Slave 1 Mode
This will allow the user to set the Slave 1 mode.
Note – This is configurable, but currently, it is not
used with the RPS The options are: MMI, Modbus master, Yokogawa, or Modbus host.
Slave 2 Baud
This will allow the user to set the Slave 2 baud rate.
Note – This is configurable, but currently, it is
not used with the RPS
The options are:
1200
14400 57600