Teac C-02 - Manual (Page 17)

17
En
gl
is
h
Additional settings (1)
3
Press the INPUT buttons (l/;) to change the setting.
4
Press the SETUP button repeatedly until the display
resumes showing its usual contents.
Setting mode ends when the usual contents are shown.
If you press the CLEAR button or do not press any buttons for 10
or more seconds, it will also exit setting mode and the display will
resume showing its usual contents.
0 These settings will be retained even if the power cord is
disconnected.
You can also make the following settings and restore factory defaults.
Volume display
Volume curve
Output
Through (RCA2)
Illumination
Input source name
Automatic display (FL) off
Automatic power saving time
1
Press and hold the SETUP button for about 2 seconds.
Press about
2 seconds
“Display>***” appears on the display and the unit enters setting
mode.
2
Press the SETUP button repeatedly to select the set-
ting item you want to change.
Each time you press the SETUP button, the display changes.
0 To exit setting mode and return to the ordinary display, do
nothing for at least 10 seconds or press the CLEAR button.