Teac C-02 - Manual (Page 19)

19
En
gl
is
h
Illumination
(Light>***)
You can set whether or not the tops of the knobs light. The default
setting is ON.
OFF
The tops of the knobs do not light.
ON
When the knobs are operated, their tops light.
Through (RCA2)
(RCA2>***)
You can select whether to use the RCA 2 jacks as normal input con-
nectors or as signal through connectors.
The default setting is “NML”.
NML (normal)
Select this to use the RCA 2 jacks as normal input connectors.
THRU (through)
The volume level adjusted using the VOLUME knob is ignored when this
setting is selected. Sound signals passing through the RCA 2 jacks are
output as they are. (No gain adjustment is made by the preamplifier.)
After selecting “THRU”, press the ON/LIGHT button to activate the
setting.
“THRU” appears on the display instead of the volume level set by using
the VOLUME knob.
For example, if you connect the pre-out jacks (FRONT L/R) of an AV
amplifier to this unit’s RCA 2 jacks, and set RCA2 to “THRU”, you can
also use the speakers connected through this unit as the front speak-
ers of the AV amplifier. (When set to “RCA2”, the AV amplifier controls
volume adjustment.)
0 If through output (RCA2) is set to THRU and the input source
is RCA 2, the VOLUME knob will not function.
Q Since this unit’s VOLUME knob will not function when set
to “THRU”, be careful if you connect a device that does
not have a volume control to the RCA 2 inputs. When you
change the input source to RCA2, very loud sounds could
be output suddenly, resulting in harm to your hearing
and damage to the speakers.
When connecting a device that does not have a volume
control to the RCA 2 inputs and setting RCA2 to “THRU”,
always connect a device that has a volume control to this
unit’s analog output connectors (LINE OUT). Use that
device to minimize the volume before switching the input
source to RCA2, and then gradually raise the volume level.