Teac K-05X - Manual (Page 21)

21
En
gl
is
h
This unit can be used as a D/A converter when its input source is set
to an external digital input (COAX in, OPT in or USB in).
Changing the input source
When stopped, press the MODE button repeatedly to cycle through
the following input sources.
CD/SACD COAX in
(coaxial digital input)
USB in OPT in
(USB input for
computer)
(optical digital input)
o When an external digital input (COAX in, OPT in, USB in) is
selected, the name and sampling frequency of the selected input
appear on the display. If there is no input signal or the unit is not
locked to the input signal, the input sampling frequency is not
shown and the input name blinks.
o If the input signal is not a digital audio signal or uses an audio sig-
nal format that is not supported by this unit (such as Dolby Digital,
dts or AAC) “- - -” appears in place of the sampling frequency. Set
the digital output of the connected equipment to PCM audio
output.
o When an external input (COAX in, OPT in, USB in) is selected,
disc controls other than the tray open/close (-) button do not
function.
D/A converter mode Dimmer
You can adjust the brightness of this unit's display and indicators.
FL Dimmer3
c
FL Dimmer2
c
FL Dimmer1
c
Off
(normal brightness)
o If you select “Off”, the display and the indicators will be unlit.
o In this mode, the display will light at normal brightness for about 3
seconds when you press 7 or another button.
o Even when set to any value other than Dimmer3, normal bright-
ness (Dimmer3) will be used when displaying error messages and
setting menus.