Teac DM-4800 Effect List - Manual (Page 12)

Effect parameter list
1
TASCAM DM-4800 Effect list
Parameter Indicator Range Description Remarks
Envelope target
parameter Envelope
Trgt WetDryMix, Output, FeedbackAmt, Wet
Pan, Dry Pan, LFO Frequency, LFO Gain,
HFD Frequency, HFD Gain, Both Frequency,
Both Gain Selects a parameter that
is influenced by enve-
lope follower output. Parameter value will
change according to
value of the envelope
follower. The maximum
(or minimum) value
will be restricted by the
current parameter value
(not by the parameter's
maximum value). That
is, adjusting the value of
the selected target pa-
rameter will enable you
to set the parameter
value range affected by
the envelope follower.
Envelope attack
time EnvAtkTime 0 ms - 125 ms (1 ms steps) Specifies time taken
for envelope follower
value to rise to a new
value when signal input
to envelope follower
increases.
Envelope
release time EnvRlsTime 5 ms - 5000 ms (1 ms steps) Specifies time taken for
envelope follower value
to decline to a new
value when signal input
to envelope follower
decreases.
Envelope bias EnvBias 0.0% - 100.0% (0.1% steps) Specifies envelope fol-
lower output gain. You can adjust the effec-
tiveness of the envelope
follower output. This
affects how the selected
envelope target param-
eter is adjusted via the
envelope parameters.
Envelope mode EnvMode Off, Env Normal, Env Inverted, Gate
Normal, Gate Inverted Selects type of enve-
lope follower output.
The envelope follower
generates DC signals at
a level that corresponds
to audio input level. Refer to the table
footnote a) for more
information.
Gate open
threshold GateOpen 0.0% - 100.0% (0.1% steps) Specifies the threshold
at which the envelope
follower gate is open.
Gate hold time GateHold 0 ms - 1000 ms (1 ms steps) Specifies the minimum
time before opened
gate is closed regardless
of input audio level. This setting prevents
unwanted noise gen-
erated by a gate that
frequently opens and
closes.