Teac DM-4800 Effect List - Manual (Page 5)

Effect parameter list
TASCAM DM-4800 Effect list

Parameter Indicator Range Description Remarks
L channel LFO
softening L LfoSmooth 0.0% - 100.0% (0.1% steps) Specifies low-pass filter
coefficient applied to
LFO waveform. This parameter improves
unnatural sound at
discontinuous points by
smoothening out edges
of sawtooth or square
waveform.
L channel dry
delay L DryDly 0.0% - 100.0% (0.1% steps) Specifies delay of dry
signal that simulates
“through zero” flanging.
L channel
feedback
inversion L InvertFbk Off, On Determines whether
or not feedback path
output signal will be
inverted.
R channel LFO
waveform type R LfoType Linked, Off, Sine, Triangle, Sawtooth Up,
Sawtooth Down, Square Specifies LFO waveform
type.
R channel LFO
softening R LfoSmooth Linked, 0.0% - 100.0% (0.1% steps) Specifies low-pass filter
coefficient applied to
LFO waveform. This parameter improves
unnatural sound at
discontinuous points by
smoothening out edges
of sawtooth or square
waveform.
R channel dry
delay R DryDly Linked, 0.0% - 100.0% (0.1% steps) Specifies delay of dry
signal that simulates
“through zero” flanging.
R channel feed-
back inversion R InvertFbk Linked, Off, On Determines whether
or not feedback path
output signal will be
inverted.
Low shelving
filter frequency LoShelfFreq 20.000 Hz - 20.00 kHz (6 cents steps) Specifies low shelving
filter corner frequency. This filter is applied to
feedback loops.
Low shelving
filter gain LoShelfGain –20.0 dB - 0.0 dB (0.1 dB steps) Specifies low shelving
filter gain. This filter is applied to
feedback loops.
High shelving
filter frequency HiShelfFreq 20.000 Hz - 20.00 kHz (6 cents steps) Specifies high shelving
filter corner frequency. This filter is applied to
feedback loops.
High shelving
filter gain HiShelfGain –20.0 dB - 0.0 dB (0.1 dB steps) Specifies high shelving
filter gain. This filter is applied to
feedback loops.
Input cross feed
amount In X-Feed 0% - 100% (1% steps) Specifies amount of L
(R) channel input signal
sent to R (L) channel
delay line.
Cross feedback
amount Fbk X-Feed 0% - 100% (1% steps) Specifies amount of L (R)
channel feedback signal
sent to R (L) channel
feedback path.