Preparation, Power sources, Using a aaa battery – Teac DR-10X User Manual

Page 11: Power supply status indicator, Connecting with a microphone, Turning the unit on and off, Turning the unit on

Advertising
background image

TASCAM DR-10X

11

Preparation

Power sources

This unit can operate on one AAA battery or USB bus

power using the included USB cable.
This unit can use an alkaline, Ni-MH or lithium AAA

battery.

Using a AAA battery

Open the battery compartment cover on the back

of the unit. Install 1 AAA battery in the compartment

with the ¥ and ^ marks as shown. Then, close the

battery compartment cover.

When using a AAA battery, set the type of battery

in order to accurately show the amount of power

remaining and allow the unit to accurately determine

whether power is available for proper operation. (See

“Making menu settings” on page 15.)

CAUTION

• AAA manganese dry cell batteries cannot be

used with this unit.

• This unit cannot recharge AAA Ni-MH batteries.

Use a commercially-available recharger.

Power supply status indicator

When operating on battery power, a battery icon

appears at the top right of the display.
The battery icon shows the amount of power

remaining in bars ( q q ).
The battery is almost dead and the power will soon

turn off if the icon with no bars blinks. When

operating on USB bus power, the icon appears.

Connecting with a

microphone

Connect the XLR connector to the microphone.

NOTE

• Turn the clamp nut in the opposite direction

of CLAMP> and then attach the mic to the

connector.

• If the connection is loose between this recorder

and the mic, turn the clamp nut in the direction

of the arrow to secure it.

• Do not hold the DR-10X when it is connected to

a mic. (Hold the mic.)

Clamp nut

Turning the unit on and off

CAUTION

Do not wear connected headphones when

turning the unit on and off. A loud noise could

damage to the speakers or harm your ears.

Turning the unit on

When the unit is off, slide the ¤?o0REC

switch toward ¤ and hold it for about one second

until the

TASCAM DR-10

startup screen appears

and the unit starts.
The Home Screen shown below appears after the

unit starts up.

NOTE

If the unit is not used for a few minutes, the

display will appear as below in screensaver

mode.

Advertising