Vir2 Instruments Acou6tics Manual User Manual
Page 28
a
c
ou6tics
49
Acou
6
tics/Advanced Setup
PITCHBEND & VIBRATO
SETUP
Acou
6
tics/Advanced Setup
STRUMMING SETUP
c
HAP
tER 13
/ PIT
CHBEND &
VIBRA
TO SETUP
c
HAP
tER 14
/
STRUMMING
SETUP
Pitchbend | Range:
Change the pitch bend range here.
Vibrato | Mode:
Change the vibrato mode here.
• All Strings
• Last String | Note: Only works with chord detection = 0ms
• Highest String | Note: Only works with chord detection = 0ms
• Lowest String | Note: Only works with chord detection = 0ms
Vibrato | curve:
Change the vibrato curve here.
Vibrato | Max:
Change the maximum strange (?) of the vibrato here.
Vibrato Speed | Min/Max:
Set up the minimum and maximum rate of the vibrato here.
Vibrato | type:
There are 2 options for vibrato type: ‘
Up’ and ‘Up & Down’. On a real guitar
you can only bend upwards, not downwards. So the default setting here is
‘
Up’, which means that the vibrato is always slightly sharp compared to
traditional LFO vibrato.
Strum | Default:
Set up the default strum type for chords played on the keyboard here.
Strum time | Auto Adjust:
Strum time in Acou6tics means the time difference between one string and
the next in a strum. If ‘
Strum time’ is set to 10ms, a strum over all six strings
for example will take 60ms. ‘
Auto Adjust’ will automatically vary this strum
time. If a six string strum takes 60ms, a four string strum will also take
60ms, because the engine automatically compensates the strum time when
playing a four string strum. You can also set up the amount of ‘
Auto Adjust’
here. 100% means full adjustment, 10% for example, means that a four string
strum will only be slightly slower than a six string strum.
DoWN-StRoKE | UP-StRoKE
Strum Speed | Start:
Set up the strum speed at the beginning of a strum here. If you set it to
110% and you have a strum time of 100ms, the strum speed at the beginning
of the strum will be 110ms. The ‘
Strum Speed | Start’ and ‘Strum Speed |
End’ settings will allow you to accelerate or slow down a strum over time.
Strum Speed | End:
Set up the strum speed at the end of a strum here. If you set it to 90% and
you have a strum time of 100ms, the strum speed at the end of the strum
will be 90ms. The ‘
Strum Speed | Start’ and ‘Strum Speed | End’ settings
will allow you to accelerate or slow down a strum over time.
cHAPtER 13
cHAPtER 14
50