Watson-Marlow PF22 - Manual (Page 15)

Operators Manual
PF22
PF22 OM EN 74-132-005 v1.02.doc Version: 1.02 Page 15 of 34
18. Timer 2: Delay BEFORE filling with diving needle
Value: seconds
Range: 0.1 – 25 in increments of 0.1 seconds.
The timer is used to control the delay needed, when the PF22 is used in combination with a diving
needle.
The timer starts AFTER the GO signal is sent to the pump, to allow the diving needle to reach
bottom position before filling starts.
19. Timer 3: Delay AFTER filling with diving needle
Value: seconds
Range: 0.1 – 25 in increments of 0.1 seconds.
The timer is used to control the delay needed, when the PF22 is used in combination with a diving
needle.
The timer starts after the pump has finished allowing the diving needle to return to top.
20. Operator number
An operator number can be entered in Function 20.
The maximum number of digits in an operator number is 10.
This means that an operator number is an integral number between 0 and 9999999999.
With this function it is possible to inform the system which operator is in charge of the current
production. The operator number entered will always appear on print-outs of the log (F24) and the
operating parameters (F29).
21. Batch number
A batch number can be entered in this function.
The maximum number of digits in a batch number is 10.
This means that a batch number is an integral number between 0 and 9999999999.
With this function the operator can inform the system of the batch or production number under
which the current production is recorded. The batch number entered will always be shown on print-
outs of the log (F24) and print-outs of the operating parameters (F29).
24. Print status
If a printer is connected, this function will start the printing of the current production status.
29. Print parameters
This function prints the current parameters via the connected printer. The print-out is for the
current drive or all the current drives.
When the function is called, the system will ask the following questions:
F29 PRN PARAM (Y/N):
F29: PRINT PARAM
For print-out of the current drive only, press <Y>.
For print-out of all connected drives, press <N>.