Westermo TD-36 - Manual (Page 30)

30 6618-2202
Windows configuration tool TD-Tool
The TD-Tool is a PC – application program with a graphical interface for easy configura-
tion of the complex functions found on the encolsed CD or at the Westermo website.
Please refer to TD-Tool for a complete description of the functionality of the Windows
program.
AT-Commands
Please refer to the AT Commands Interface Guide found on the enclosed CD or at
the Westermo website for a complete list of all available AT-commands and a detailed
description of the serial AT-command interface.
Configuration
The TD-36 (485) can be configured both from the local DTE interface and remotely over
the PSTN network. Whether the local or remote interface is used the configuration can
be made with AT-commands or with a PC-based application configuration tool. Basic
configurations can also be made with DIP switches locally.Remote configuration
The TD-36 (485) can be configured from a remote modem. To configure a TD-36 (485)
any GSM, ISDN or PSTN modem can be used.
The modem used to configure is referred as the “local modem”.
Please make sure that the remote TD-36 (485) is connected to the PSTN network and is
powered up.
… Connect the local modem to it's media (ISDN, PSTN or GSM)
… Connect the PC's com-port to the DTE interface of the local modem.
… Connect the power supply.
… Start a terminal emulation program (i.e. Windows Hyper-Terminal).
… Configure the local modem data rate and word format.
… Set up a connection to the remote TD-36 (485) to be configured by using the
normal dial command: ATD<No><CR>. When connected send the remote escape
sequence <++++>. The called remote TD-36 (485) will acknowledges by request-
ing the remote password. Enter the correct password (default: no password, just
return). Next; configure the remote TD-36 (485) using AT-commands. The pass-
word for remote configuration is defined with AT*WRCP – Remote configuration
password.
… Configure the parameter on the remote TD-36 (485) from your terminal program
and save the settings with AT&W.
… Hang up the connection using the ATH command.