Westermo TD-34 - Manual (Page 39)

39 6610-2203
*WIOD – General IO delete entry
This command delete an IO entry in the list.
Syntax: AT*WIOD=<index>[,<start,stop>]
AT*WIOD=?
<index>
IO entry index
[,<start,stop>] IO entry start,stop index
Examples: AT*WIOD=2
OK
AT*WIOD=3,7
OK
AT*WIOD=?
*WIO: (1-8)[,(1-8)]
OK
Result Codes: OK <index>[,<start,stop>] = (1-8)[ (1-8,1-8)]
ERROR Otherwise
*WIOP – General IO parameters
This command set the IO parameters.
Syntax: AT*WIOP=<t0>,<t1>,<type>,<trig>,<norm>
AT*WIOP=?
AT*WIOP?
<t0>
Min trig pulse time in 10 ms [0-255]
<t1> Max trig pulse time in 10 ms [0-255]
<type> Trig pulse type [0=NO, 1=LEVEL, 2=PULSE]
<trig> Pulse trig type [0=NO, 1=HIGH, 2=LOW, 3=POS, 4=NEG]
<norm> Normaly [0=NO, 1=OPEN, 2=SHORT, 3=DCD, 4=DTR]
Examples: AT*WIOP=5,10,1,1,3
OK
AT*WIOP=,,2,,
OK
AT*WIOP?
*WIO :TMIN=5,TMAX= 10,TYPE=2,TRIG=1, NORM=3
OK
Result Codes: OK <t0>,<t1>,<type>,<trig>,<norm> = (0-255), (1-255), (0-2),
(0-4), (0-4)
ERROR Otherwise:
*WRAE – End remote access
This command end the remote access session.
Syntax: AT*WRAE
Examples:
Result Codes: OK