Westermo TD-34 - Manual (Page 42)

42 6610-2203
Y – Long Space Disconnect
This command enables/disables the generation and response to long space disconnect.
The parameter value, if valid, is written to S21 bit 7.
Y0 Disables long space disconnect. (Default)
Y1 Enables long space disconnect. In non-error correction mode, the modem will send
a long space of four seconds prior to going on-hook. In non-error correction mode,
the modem will respond to the receipt of a long space (i.e., a break signal greater
than 1.6 seconds) by going on-hook.
&Y – Designate a Default Reset Profile
This command selects which user profile will be used after a hard reset.
&Y0 The modem will use profile 0.
&Y1 The modem will use profile 1.
Z – Software reset
The modem performs a soft reset and restores (recalls) the configuration profile according to
the parameter supplied. If no parameter is specified, zero is assumed.
Syntax: ATZ<value>
<value> = 0 Soft reset, profile 0
= 1 Soft reset, profile 1
Examples:
Result Codes: OK
<value> = (0-1)
ERROR Otherwise
&Z=x – Store Telephone Number
The modem can store up to two telephone numbers and each telephone number dial string
can contain up to 34 digits.
&Zn=x n = 0 to 1 and x = dial string.