ZeeVee EAS - Emergency Alert System (QAM & DVB-T/C) - Manual (Page 7)

7 w w w . z e e v e e . c o m
G E N E R A T I N G E A S A L E R T S
In the Setup section:
1. Click on Net Alerts, and click on the
Stream Mpeg tab.
2. Configure the following for each
ZeeVee device that receives alerts
from the Monroe R189:
• Ensure MPEG 1/2 Video Format is
set to MPEG2:D1-720
• Ensure MPEG Audio Format is set to
VLC A52(AC3)
• Ensure MPEG Audio Bitrate is set to
192Kbits/sec
• Ensure MPEG Audio Sample rate is
set to 48K samples/sec
• Ensure remote host address
matches the ZeeVee device (Remote
Host Unicast or Multicast IP Address)
• Ensure the Remote Host Port
matches the remote host port value
Configuring EAS MPEG Streaming Alerts
Once the network and time configuration have been verified the next step is to configure EAS MPEG.
The image shows settings needed for the ZeeVee modulator to process the alerts
from the R189.