ARM Electronics RT4CD - Manual (Page 52)

APPENDIX #1 APPENDIX #1
APPENDIX #1 APPENDIX #1 – – INSTALL HDD INSTALL HDD
Carefully follow the steps to ensure correct installation.
*** Note: Please set the HDD to “Master Mode” or “Single Mode” ***
2) Screw out the HDD bracket.
For the positions of the HDD bracket screws,
please refer to the right figure.
49
1) Open the upper cover of the DVR:
Loosen the two screws respectively on the two sides of the upper cover.
Loosen the four screws on the back side of the upper cover.
3) Screw HDD onto the HDD bracket, two
screws for each side. There are three
screw holes per side on the bracket and
you can choose two of them to secure
the HDD. And then screw the HDD
bracket back to the DVR base.
4) Connect the HDD to the power
connector and IDE BUS (make sure to
align the HDD precisely for pin
connection). And then close the upper
cover of the DVR and fasten all the
screws you loosened in the step 1.
(Model 1) (Model 1)