H3C Technologies H3C S10500 Series Switches User Manual
Page 42
[Sysname-irf-port2] quit
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] undo shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
# Specify the priority of Device A as 10 to make sure that it is elected as the master when the IRF fabric
is established.
[DeviceA] irf priority 10
# Save the current configuration to the startup configuration file.
[Sysname] quit
<Sysname> save
# Change the operating mode of the device to IRF.
<Sysname> system-view
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup. Continue?
[Y/N]:y
Do you want to convert the content of the next startup configuration file
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
The device operates in IRF mode after reboot.
2.
Configure Device B
# Set the member ID of Device B to 2, create IRF port 1, and bind it to physical port Ten-GigabitEthernet
3/0/1.
<Sysname> system-view
[Sysname] irf member 2
Info: Member ID change will take effect after the switch reboots and operates in IRF
mode.
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
[Sysname] irf-port 1
[Sysname-irf-port1] port group interface ten-gigabitethernet 3/0/1
[Sysname-irf-port1] quit
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] undo shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
# Save the current configuration to the startup configuration file.
[Sysname] quit
<Sysname> save
# Connect the two devices as shown in
.
# Switch the operating mode of the device to IRF.
<Sysname> system-view
36