H3C Technologies H3C SR6600 - Manual (Page 24)

16
Figure 16 Push the MIM into the slot
Step3 Use a flat-blade screwdriver to fasten the captive screws on the MIM.
Step4 Power on the router and check the status LED on the front panel. On means the MIM is installed correctly
and running properly. Off means the MIM has failed the POST.
NOTE:
HIMs are hot swappable and you must perform the remove slot number command to stop the module
before you remove it.
Installing a CF card
Follow these steps to install a CF card:
Step1 Make sure that the CF card status LED is not flashing.
Step2 Push the CF card eject button all the way into the slot, and make sure that the button does not project from
the panel.
Step3 Insert the CF card into the slot following the direction shown in Figure 17 , and make sure it does not
project from the slot.
Figure 17 Insert the CF card into the slot