H3C Technologies H3C SecBlade LB Cards - Manual (Page 91)

80
Figure 31 Adding an account for device management
Configuring LB
# Assign an IP address to interface GigabitEthernet 0/1, the Telnet user access interface.
<LB> system-view
[LB] interface gigabitethernet 0/1
[LB-GigabitEthernet0/1] ip address 192.168.1.70 255.255.255.0
[LB-GigabitEthernet0/1] quit
# Configure the IP address of interface GigabitEthernet 0/2, through which LB communicates with the
server.
[LB] interface gigabitethernet 0/2
[LB-GigabitEthernet0/2] ip address 10.1.1.2 255.255.255.0
[LB-GigabitEthernet0/2] quit
# Enable the Telnet server on LB.
[LB] telnet server enable
# Configure LB to use AAA for Telnet users.
[LB] user-interface vty 0 4
[LB-ui-vty0-4] authentication-mode scheme
[LB-ui-vty0-4] quit
# Create RADIUS scheme rad.
[LB] radius scheme rad
# Specify the primary authentication server.
[LB-radius-rad] primary authentication 10.1.1.1 1812