Grass Valley 8964FS - Manual (Page 17)

8964FS Instruction Manual 17
Configuration
Local Onboard Module Configuration
The 8964FS module can be configured locally using the rotary and paddle
switches. Several LEDs interact with the switches to indicate status of the
configuration process.
Configuration Switches and Controls
Each of the four channels is adjusted separately. Selection of each channel
is done with the paddle switch while in Channel Select Mode as explained
below. Refer to
Figure 5 on page 18 for the following descriptions. Use the
onboard configuration components as follows:
• Function (rotary) switch — This switch accesses a desired function for
configuration (see
Table 7 on page 21 ). The switch addresses up to three
banks of functions; each bank has 16 possible positions (0 through 9 and
A through F). Not all positions are used.
The next bank of functions is accessed each time the Function switch
makes a complete revolution past zero (or back through F): While in
Bank 1, a complete revolution past zero accesses Bank 2. The yellow
2ND LED indicates which bank is currently being accessed.
Note The Function switch should be kept in position 0 in any bank (parked) when
not in use to avoid any inadvertent change in configuration. Position 0 in each
bank is inactive.
• 2ND (second Function) yellow LED – when off, indicates that the rotary
switch is addressing the first bank of functions. When on, indicates that
the rotary switch is addressing the second bank of functions.
• SW2 (paddle) switch – actuates or selects the desired setting or channel
selection for the selected function when the switch is held momentarily
in either the up or down position. Switch between Parameter and
Channel Select Mode with pushbutton SW4.
• CSM (Channel Select Mode) yellow LED – when on, paddle switch is in
Channel Select Mode. Use the paddle switch to select channel 1, 2, 3, or
4. When off, paddle switch is in Parameter mode.
• CM1 and CM0 yellow LEDs – indicate what channel is active for adjust-
ment. Refer to
Table 6 on page 18 .
• SW4 (pushbutton) switch – press to toggle assignment of paddle switch
SW2 between Parameter mode (CSM LED off) and Channel Select
Mode (CSM LED on).
• CONF (configuring) yellow LED – when on, indicates the module is
programming hardware.