Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 342)

342 K2 Storage System Instruction Manual September 7, 2007
Chapter 8 Installing the Level 10R Storage System
9. Click Modify Selected Ports .
10.Make sure Port Enabled is set to Yes , leave Mode as default of Auto .
11.Set Flow Control as follows:
• Set to Enable .
NOTE: This setting is for the 2900 series switch. Other switch models might require
a different setting.
12.Click Apply Settings . Wait until settings are applied and the Web interface
becomes active.
13.Choose VLAN Configuration . If prompted, log in with the switch’s administrator
username and password.
This setting varies
depending on
switch model. Set
as instructed in
text.