Grass Valley K2 Summit Storage Area Network v.7.1 - Manual (Page 348)

26 October 2009 K2 Storage Area Network Installation and Service Manual 348
Configuring a K2 client for the K2 Storage System
NOTE: If your system has a large number of K2 clients and other iSCSI clients, you
are prompted to restart the K2 Media Server when you configure clients and cross
the following thresholds: 64 clients; 80 clients; 96 clients.
On this page… Do this…
Page 1
Enter the IP address or network name for a K2 client, as currently
configured on the K2 client. You should configure your highest
bandwidth K2 clients first, as this ensures load balancing is correct. For
the Storage Access settings, leave
iSCSI selected.
Click Next
Software Configuration
This page checks the K2
client for required software.
NOTE: Multi-Path
I/O software must
be installed on K2
clients connected to
a redundant K2
SAN.
If software with Yes in the Required column reports as Not Installed, you
must first install it on the K2 client before continuing. After installing the
software, click
Check Software . When all required software reports as
Installed, click Next .