Save configuration, Test lower level control, Save – Grass Valley Machine Control Interfaces V.12.0 User Manual
Page 55: Configuration
Kalypso Machine Control Interfaces Installation Instructions
55
Encore Configuration
15.
Set the
Chnl. ID
field for the Profile channel. Use
1
(back space over any
existing characters) for the first Profile channel.
16.
Enable
that channel by selecting the small box above the name field so it
is green. Your menu should then look like
.
Figure 47. Encore Profile Device with Configuration Data
17.
for the other channels, incrementing
the Port, Channel No, and Channel ID values. The Name, Type, and
Protocol fields should be the same for all the channels on that Profile.
Save Configuration
18.
Click on
SAVE
on the right to save configuration for all the channels. A
confirmation message box will appear over the window.
19.
Click on the message box to close it.
Test Lower Level Control
You can now test communication and control to the Profile using VDRCS.
This test uses the Profile’s Native Protocol and does not use the Encore
Machine Control configuration settings.