Grass Valley Machine Control Interfaces V.12.0 - Manual (Page 79)

Kalypso Machine Control Interfaces Installation Instructions 79
Encore Configuration
Access OUI and Log In
Access OUI and Log In as SYS
1. Make sure that the Kalypso Menu panel and Serial Engine are both
connected to the network and that their IP addresses are on the same
subnet.
2. Press the Facility Manager button on the Kalypso Menu panel to go to the
Encore OUI ( Figure 63 ).
Note Do not use the older wincui icon, if still present on your system.
Figure 63. Encore Welcome Message. KAL Login
3. Click the button on the lower right corner of the menu labeled either
Start (not logged in) or with the login name ( KAL is the default shown in
Figure 63 ).