Grass Valley PROFILE FAMILY v.2.5 - Manual (Page 164)

Chapter 4 Using VdrPanel
164 Profile Family
Selecting Clip Length (BVW Only)
If you have chosen a BVW controller, you can specify clip length by setting
mark in and mark out points:
NOTE: The Set Clip Marks (clip length) dialog box shown here will
not appear unless the panel controller is a BVW controller. This is
not the same as setting clip length while in Loop or Bounce mode.
1. Click a panel to make it active.
2. Choose Controller | Clip Length . The Set Clip Marks dialog box appears
(Figure 79).
Figure 79. Set Clip Marks dialog box
3. Enter the mark-in and mark-out points by specifying the hour, minute,
second, and frame settings. This applies to future clips only, unless you
perform step 4.
4. Click Apply to Loaded Clip(s ) if you want the mark-in and mark-out points
to apply to existing clips as well as future clips.
5. Click OK .