HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual
Page 266
8-46
8
Cycles
TNC 426/TNC 425/TNC 415 B/TNC 407
Editing a datum table
Datum tables are edited in the PROGRAMMING AND EDITING mode:
Show the datum table.
Select the desired file.
Enter new file name, such as TAB.D .
Edit the datum table.
The soft keys comprise the following functions for editing:
Function
Soft key
Go to the beginning of datum table
Go to the end of datum table
Page up
Page down
Insert line
Delete line
Enter line, go to beginning of
next line
• If you are using only one datum table, be sure to activate the correct datum in the program run modes of
operation.
• Datums from a datum table can be referenced either to the current datum or to the machine datum.
The desired setting is made in MP 7475 (see page 11-14).
• New lines can only be inserted at the end of the file.
PGM
NAME
T A
+
+
+
B
PGM
MGT