HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual
Page 314
11-17
11 Tables, Overviews and Diagrams
TNC 426/TNC 425/TNC 415 B/TNC 407
11.2 Miscellaneous Functions (M Functions)
Miscellaneous functions with predetermined effect
M Effect Effective at block Page
start end
M101 Automatic tool change with replacement tool
if maximum tool life has expired • 4-16
M103 Reduce feed rate during plunging to factor F (percentage) • 5-40
M105 Machining with first Kv factor •
M106 Machining with second Kv factor •
M107 Suppress error message for replacement tool with oversize •
M108 Reset M107 •
M109 Constant contouring speed at tool cutting edge on circular arcs
(increase and decrease feed rate) • 5-41
M110 Constant contouring speed at tool cutting edge on circular arcs
(feed rate decrease only) • 5-41
M112 Automatic insertion of rounding arcs at non-tangential straight-line
transitions; Enter tolerance T for contour deviation • 5-41
M114 Automatic compensation of machine geometry during operation
M116 Feed rate for angular axes in mm/min • 5-43
M126 Optimized traverse of rotary axes • 5-44
M127 Reset M126 • 5-44
The miscellaneous functions M105 and M106 are defined and enabled by the machine tool builder.
Please refer to your machine manual for more information.