HEIDENHAIN SW 68894x-02 - Manual (Page 406)

406 ICP programming
5.1
0 Cont
our elements on lat
er
al surf
ace
Vertical lines on lateral surface
Select the line direction.
Enter the line dimensions and define the transition to the next contour
element.
In smart.Turn, ICP generates a G111.
Horizontal lines on lateral surface
Select the line direction.
Enter the line dimensions and define the transition to the next contour
element.
In smart.Turn, ICP generates a G111.
Parameters
CY
Target point as linear dimension (reference: diameter XS)
CYi Incremental target point as linear dimension (reference:
diameter XS)
P Target point as polar radius
C Polar target point (angle)
Ci Incremental polar target point – angle
L Length of line
F: See machining attributes Page 361
Parameters
Z
Target point
Zi Incremental target point
P Target point as polar radius
L Length of line
F: See machining attributes Page 361