HEIDENHAIN SW 68894x-02 - Manual (Page 430)

430 ICP programming
5.13
Lat
er
al
surf
ace
cont
ours
in
smar
t.T
u
rn
Circular pattern on lateral surface
Reference data: (see "Reference data of lateral surface" on page 421)
Reference data of lateral surface
ID
Contour name
PT Milling depth
XR Reference diameter
Parameters of pattern
Z
Center of pattern
CY Center of pattern as linear dimension (reference: diameter XR)
C Center of pattern (angle)
QP Number of points in pattern
DR Direction of rotation (default: 0)
 DR=0, without EP: Figures are arranged on a full circle
 DR=0, with EP: Figures are arranged on the longer circular
arc
 DR=0, with EPi: The algebraic sign of EPi defines the
direction (EPi<0: clockwise)
 DR=1, with EP: clockwise
 DR=1, with EPi: clockwise (algebraic sign of EPi has no
effect)
 DR=2, with EP: counterclockwise
 DR=2, with EPi: counterclockwise (algebraic sign of EPi has
no effect)
DP Pattern diameter
AP Starting angle (default: 0°)