HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 149)

HEIDENHAIN TNC 320 149
5.2 T
ool D
a
ta
There are two ways to run a tool usage test for a pallet file:
„ The highlight is on a pallet entry in the pallet file:
The TNC runs the tool usage test for the entire pallet.
„ The highlight is on a program entry in the pallet file:
The TNC runs the tool usage test only for the selected program.
RAD Tool radius R + Oversize of tool radius DR
from the tool table (in mm).
BLOCK Block number in which the TOOL CALL block
was programmed
PATH „ TOKEN = TOOL: Path name of the active main
program or subprogram
„ TOKEN = STOTAL: Path name of the
subprogram
T Tool number with tool index
OVRMAX Maximum feed rate override that occurred
during machining. During test run, the TNC
enters the value 100 (%)
OVRMIN Minimum feed rate override that occurred
during machining. During test run, the TNC
enters the value -1
NAMEPROG „ 0 : The tool number is programmed
„ 1 : The tool name is programmed
Column Meaning