HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 369)

HEIDENHAIN TNC 320 369
14.1 Gr
aphics
Setting the speed of the test run
After you have started a program, the TNC displays the following soft
keys with which you can set the simulation speed.
You can also set the simulation speed before you start a program:
U Switch to the next soft-key row
U Select the function for setting the simulation speed
U Select the desired function by soft key, e.g.
incrementally increasing the test speed
The most recently set speed remains active, even if the
power is interrupted, until you change it.
Functions Soft key
Execute test run at the same speed at which the
program will be run (programmed feed rates are
taken into account).
Increase the test speed incrementally.
Decrease the test speed incrementally.
Test run at the maximum possible speed (default
setting).