HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 434)

434
M101
M102 Automatic tool change with replacement tool if maximum tool life has expired
Reset M101 „
„
Page 146
M109
M110
M111
Constant contouring speed at tool cutting edge
(increase and decrease feed rate)
Constant contouring speed at tool cutting edge
(feed rate decrease only)
Reset M109/M110 „
„
„
Page 279
M116
M117 Feed rate for rotary axes in mm/min
Reset M116 „
„
Page 320
M118 Superimpose handwheel positioning during program run „ Page 282
M120 Pre-calculate radius-compensated contour (LOOK AHEAD) „ Page 280
M126
M127 Shortest-path traverse of rotary axes
Reset M126 „
„
Page 321
M130 Moving to position in an untilted coordinate system with a tilted working plane „ Page 274
M140 Retraction from the contour in the tool-axis direction „ Page 283
M144
M145
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL
positions at end of block
Reset M144 „
„
Page 324
M141 Suppress touch probe monitoring „ Page 284
M148
M149 Retract the tool automatically from the contour at NC stop
Reset M148 „
„
Page 285
M Effect Effective at block... Start End Page