6 optional block skip, Function, 6 optional bloc k skip 11.6 optional block skip – HEIDENHAIN TNC 426 (280 476) User Manual
Page 442
Advertising
HEIDENHAIN TNC 426, TNC 430
415
1
1
.6 Optional Bloc
k Skip
11.6 Optional Block Skip
Function
In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:
7
7
7
7
To run or test the program without the blocks
preceded by a slash, set the soft key to ON.
7
7
7
7
To run or test the program with the blocks preceded
by a slash, set the soft key to OFF.
This function does not work for TOOL DEF blocks.
After a power interruption the TNC returns to the most
recently selected setting.
Advertising
This manual is related to the following products: