SMA SB 3000TL - Manual (Page 19)

Figure 4: Recommended clearances
Permitted and prohibited mounting positions:
☐ The inverter must be mounted in one of the permitted positions. This will ensure that no
moisture can penetrate the inverter.
☐ The inverter should be mounted in such way that display messages and LED signals can be
read without difficulty.
Figure 5: Permitted and prohibited mounting positions
5.2 Mounting the Inverter
Additionally required mounting material (not included in the scope of delivery):
☐ Three screws suitable for the support surface (diameter: at least 6 mm)
☐ Three washers suitable for the screws (outer diameter: at least 18 mm)
☐ If necessary, three screw anchors suitable for the support surface and the screws
☐ To secure the inverter against theft: one padlock suitable for outdoor use
5 Mounting SMA Solar Technology AG
Operating Manual 19 SB30-50TL-21-BE-en-11