SMA SB 3000TL - Manual (Page 33)

All BLUETOOTH devices in a PV system must have the same NetID. You can set a new NetID in the
inverter by means of the rotary switch C.
Figure 8: Positions of rotary switch C
Position Explanation
0 Communication via BLUETOOTH is deactivated.
1 Communication via BLUETOOTH with a further BLUETOOTH device
2 to F NetID for communication via BLUETOOTH with multiple BLUETOOTH devices
Procedure:
1.
Danger to life due to high voltages
• Ensure that the inverter is disconnected from all voltage sources (see Section 10, page 45
).
2. To set a new NetID, set the rotary switch C to the
determined NetID using a flat-blade screwdriver
(blade width: 2.5 mm).
3. To deactivate communication via BLUETOOTH,
set the rotary switch C to position 0 using a flat-
blade screwdriver (blade width: 2.5 mm). This
will protect your PV system from unauthorized
access.
☑ The inverter will adopt the setting after commissioning. This can take up to five minutes.
7 Commissioning SMA Solar Technology AG
Operating Manual 33 SB30-50TL-21-BE-en-11