Yaskawa PG-X3 Line Driver - Manual (Page 21)

22 YASKAWA ELECTRIC TOBP C730600 37B 1000-Series Option PG-X3 Installation Manual
6 Related Parameters
6 Related Parameters
The following parameters are used to set up the drive for operation with the option. Set
parameters as needed. Parameter setting methods can be found in the drive Quick Start
Guide or Technical Manual.
Table 6 Related Parameters
No.
(Addr. Hex)
Name Description
Control
Method
Values
A1-02
(102)
Control
Method
Selection
0: V/f Control
1: V/f Control with PG
2: Open Loop Vector Control
3: Closed Loop Vector Control
5: Open Loop Vector Control for PM
6: Advanced Open Loop Vector Control for PM
7: Closed Loop Vector Control for PM
All Modes
Default: <1>
Range: <1>
F1-01
(380)
<2> <3>
PG 1 Pulses
per Revolution
Sets the pulses to be read from the pulse generator.
V/f w/ PG
CLV
CLV/PM Default: <1>
Min: <1>
Max: <1>
F1-02
(381)
PG Feedback
Loss Operation
Selection
Sets the stopping method when the PG becomes
disconnected (PGo).
0: Ramp to stop (decelerates at time set to C1-02)
1: Coast to stop
2: Fast Stop (decelerates at the time set to C1-09)
3: Continue running
4: No alarm display
Note: Due to potential damage to the motor and
machinery, only use the “Continue running” and “No
alarm display” settings under special circumstances.
V/f w/ PG
CLV
CLV/PM
Default: 1
Range:
<1>
F1-03
(382)
PG Overspeed
Operation
Selection
Sets the stopping method when overspeed is
detected.
0: Ramp to stop (decelerates at time set to C1-02)
1: Coast to stop
2: Fast Stop (decelerates at the time set to C1-09)
3: Continue running
Note: Due to potential damage to the motor and
machinery, only use the “Continue running” setting
under special circumstances.
V/f w/ PG
CLV
CLV/PM
Default: 1
Range: 0 to 3
F1-04
(383)
PG Deviation
Operation
Selection
0: Ramp to stop (decelerates at time set to C1-02)
1: Coast to stop
2: Fast Stop (decelerates at the time set to C1-09)
3: Continue running
Note: Due to potential damage to the motor and
machinery, only use the “Continue running” setting
under special circumstances.
V/f w/ PG
CLV
CLV/PM
AOLV/PM
Default: <1>
Range: 0 to 3